What Are The Binding Methods For Taiwanese Fishing Hooks?

Fish hooks are the most essential tool for fishing. The main function is to hang bait to attract fish to swallow bait. Due to different designs, they can be divided into dozens of hook types, such as Iseni, sleeve hook, Izu, Shin Kanto, etc. The hooks are suitable for different hook types. Let’s take a look at what binding methods are available for fishing hooks on the platform!

1. Outer ring style

1. First, circle the sub-line along the end of the hook handle.

2. Use the fishing line at the end of the thread to wrap the fishing line parallel to the hook handle, and place the fishing line inside the hook handle.

3. Turn the fishing line through the circle at the end of the hook handle.

4. Hold the thread tip with one hand and the fishing thread with the other hand, and tighten it in both opposite directions.

2. Inner ring style

1. Fold the fishing line in half and keep it parallel to the fish hook, and place the fish hook in the ring.

2. Then wrap it from top to bottom for about 7 turns.

3. Twist the circle into a shape of 8 and pass the thread through the circle below.

4. Pinch the hook handle and pull the thread tip. When the circle shrinks, then pull the fishing lines at both ends tightly in the opposite direction.

3. Rotary type

1. First, fold the fishing line in half and move it parallel to the hook, but leave the fishing coil slightly larger.

2. Tighten the circle with one finger or two fingers, keep it tight, and then turn your fingers.

3. When turning your fingers, turn the fish coil around the hook and seven or eight times.

4. Pull the end of the line through the circle and tighten it, and at the same time, the fishing line at the other end is also tightened.

4. Things to note

1. After the hook is tied, try to make the sub-line facing the inside of the hook, so that it is easier to stab the fish and not easily break the sub-line. In addition, the sub-line conduction angle is very good when walking the fish, making it easier to walk the fish.

2. The more circles you wrap the hook handle, the better. First, if you wrap too much, it will easily fill up residue. Second, if you wrap too much, it will make the sub-line and hook straight and not conducive to biting the hook.

3. After pulling out the sub-wire, bite the thread tip and pull it. Do not tighten it. Then turn the coil on the hook handle to face the inner side of the hook handle. Do not pull the sub-wire hard to turn it to the inner side of the hook handle.

4. After aligning the sub-wire position, push the coil towards the end of the hook handle, then bite the thread and pull it gently, but do not pull it too tightly. If it is too tight, it will easily strain the knotted part and damage the sub-wire.

5. When pulling the sub-line, you must pull it in parallel and slowly in the direction of the hook handle. This will not be easy to pull the sub-line. If the sub-line is basically scrapped, it will only be invalid.